ASIC Miner SD Card Flash Failed
Feature path: Open OKCARE, select the ASIC module, and click Create SD.
An ASIC miner SD card flash usually fails because of the card, poor card-slot contact, or the miner's current state. Check the following in order:
- Create the recovery card again: Confirm that the firmware matches the miner model, format the SD card, and write the firmware again. If it still fails, use another SD card or card reader.
- Check the card slot: Turn off the miner before reseating the SD card. Check the slot for oxidation, dust, or looseness. Use an electronics-safe cleaning method when needed, and wait until the slot is completely dry before restoring power.
- Check the miner's state: If the miner may be infected, has abnormal firmware, or cannot open its dashboard, run the OKCARE ASIC virus-removal function before flashing again.
- Check for a hardware fault: If flashing still fails with the correct firmware and a different SD card, the card slot or control board may need repair.
Turn off the miner before inserting the recovery card. Do not remove the card or interrupt power while the image is being written or the miner is starting. See ASIC Module Tutorial.
If the issue persists after these checks, contact us and provide when the issue occurred, the device or App version, the complete error message, and relevant logs. Do not send passwords, private keys, or complete verification codes.