Skip to content
Switch article
USB Creation Progress Is Stuck for a GPU MinerIP Reporter Cannot Find the Miner IPASIC Miner SD Card Flash FailedVirus Removal or Upgrade FailedOKCARE Shows a Connection Error During ScanOKCARE Shows an Incorrect Password During ScanOKCARE Shows a Network Error During Scan

OKCARE Shows a Connection Error During Scan

Operation path: Open OKCARE, select the ASIC or GPU module, click + next to IP Range, set the scan range, and click Load. After the miner appears in the list, click Scan to refresh its status.

A connection error means that OKCARE found the target IP but could not establish a normal connection to the miner. Check the following in order:

  1. Confirm that the miner is supported: Check whether the miner model and firmware version are supported by the current OKCARE version.
  2. Test the miner dashboard: Open the miner IP in a browser on the same computer. If the page does not open, confirm that the miner has finished starting, then try another network cable or switch port, or obtain its IP again.
  3. Confirm LAN connectivity: Check that the computer and miner are on the same reachable local network and that their IP address, subnet mask, gateway, and routing settings allow communication.
  4. Load the miner again: After confirming that the browser can open the miner dashboard, set the scan range again in OKCARE and reload the miner.

If the dashboard opens normally but OKCARE still reports a connection error, record the miner model, firmware version, IP address, and complete error message.

If the issue persists after these checks, contact us and provide when the issue occurred, the device or App version, the complete error message, and relevant logs. Do not send passwords, private keys, or complete verification codes.