Skip to content
Switch article
USB Creation Progress Is Stuck for a GPU MinerIP Reporter Cannot Find the Miner IPASIC Miner SD Card Flash FailedVirus Removal or Upgrade FailedOKCARE Shows a Connection Error During ScanOKCARE Shows an Incorrect Password During ScanOKCARE Shows a Network Error During Scan

OKCARE Shows a Network Error During Scan

Operation path: Open OKCARE, select the ASIC or GPU module, click + next to IP Range, set the scan range, and click Load. After the miner appears in the list, click Scan to refresh its status.

A network-unreachable message means that the computer running OKCARE cannot access the miner through the current network. Check the following in order:

  1. Confirm that the miner has started: Wait for the control board and network interface to finish starting, then scan again.
  2. Check the physical connection: Make sure the network cable is firmly connected and the Ethernet port lights are working. Try another cable or switch port.
  3. Confirm the LAN settings: The computer and miner must be on a mutually reachable local network. Check the computer IP, miner IP, subnet mask, and gateway, and make sure the scan range includes the miner IP.
  4. Test the IP in a browser: Open the miner IP on the computer. If it does not open, resolve the LAN or miner network configuration before scanning with OKCARE.
  5. Check network restrictions: Determine whether a firewall, guest network, VLAN isolation, or routing rule is blocking communication between the computer and miner.

If the issue persists after these checks, contact us and provide when the issue occurred, the device or App version, the complete error message, and relevant logs. Do not send passwords, private keys, or complete verification codes.