Skip to content
Switch article
Cannot Find a Sub-accountHow Are Hashrate Units Converted?Why Is Pool Hashrate Lower Than Local Hashrate?Why Are My Workers and Earnings Not Showing?Pool Shows Paid but Funds Were Not ReceivedWhy Was Payment Not Sent After Reaching the Threshold?Why Do Actual Earnings Differ from Estimated Earnings?Why Have My Mining Earnings Decreased?Does OKMINER Charge a Pool Payout Fee?What If an Exchange Changes My Deposit Address?High Pool Rejection RateHow Can I Receive Earnings Below the Payout Threshold?View Unpaid Earnings

Why Is Pool Hashrate Lower Than Local Hashrate?

Local hashrate is calculated by the miner, while pool hashrate is estimated from the valid shares actually received by the pool. The two values therefore do not match exactly over short periods. Compare average hashrate over a longer period rather than using instantaneous values.

Normal causes of a difference include:

  • Network latency and job switching.
  • Mining software developer fees.
  • Random variation in share submissions.

If the difference remains unusually large, check:

  1. Whether the rejection rate is high. If it is, check the internet connection, router, switch, network cable, and pool address.
  2. Whether the miner is overclocked too aggressively. Restore the default frequency or reduce it, then observe again.
  3. Whether the miner frequently restarts, disconnects, or reports hardware errors.
  4. Whether both values use the same statistical period.

As a reference, after 24 hours of stable operation, a difference of approximately 5% or less between local and average pool hashrate for a GPU miner, or approximately 2% or less for an ASIC miner, is generally within normal variation. The actual difference still depends on the coin and the number of submitted shares.